Remote Control for Fossil Fuel Pumps
The aQ2 Controller combines a sophisticated pump control module with a transmitter/receiver to control and monitor well pumps from any web-connected device, like your phone or tablet. By connecting to your personal Aquarius Management Portal (AMP), the aQ2 not only starts and stops the pump, but monitors run time, sets maintenance reminders, alerts on failures, reports RPMs and other critical data. Plus, you can connect other sensors to report on the conditions of your field.
This Kit Includes:
- aQ2 Controller/Modem unit
- Engine RPM sensor
- Power/Relay with control cable
- Backup Batteries
Features:
- Monitors pump operation and sends notifications
- Communicates via aQuarius Management Portal on any web-enabled device
- Monitors engine RPM for run verification
- Sends maintenance interval reminders
- Alerts on system status changes/faults, ex. unexpected shut off
- Crank Battery voltage level
- OTA software upgrades
- Fuel Tank Level (optional aQ-Fuel Gauge Sender)
- Monitors water flow in GPM via optional aQ2-Flow Meter
- Collects various field sensor data (optional aQReceiver and sensors)
Control
- Start and run until “Stop Immediately” command issued
- Start and Stop Automatically after set hours
Well Connectivity Data Plan Required for each pump controller. You will see a $75 data plan charge per controller in the cart. Your data plan will renew yearly at $75 until cancelled.
- Shipping Size: 14”x8”x6”
- Shipping Weight: 5 Lbs
